profile_tag 15 characters name of this set of parameters personality Voice DEFAULT Tracker KISS Digipeater Scanner my mission ttybaud 0...65535, DEFAULT 0 0: 19200 or any personality specific default ttylines 0...65535, DEFAULT 24 pause long listings. 0=unlimited app_port 1 DEFAULT 2 auto gps or kiss attached to serial 1 or 2 lobatt 0...65535, DEFAULT 0 engine monitor. wire 1/3 of +VB to AN7 freq kHz, DEFAULT 145200 rx frequency, tx too if tx_freq=0 tx_freq kHz, DEFAULT 0 0=simplex, see 'freq' tx_lockout on off DEFAULT +12v in RTS1 overrides lockout ctcss Voice, Scanner 0...65535, DEFAULT 0 deciHz, like 1188 = 118.8. 0=off autoscan Voice, Scanner on off DEFAULT voice p. scans channels when idle idle_time Voice, Scanner 0...65535, DEFAULT 30 seconds from ptt/squelch to autoscan scan_tail Voice, Scanner 0...65535, DEFAULT 5 seconds to linger before resuming scan autobeep Voice, Scanner on DEFAULT off automatic 1750Hz burst if duplex-voice ptt_packet Voice, Scanner off DEFAULT id MIC-E packet sent after voice ptt rx_if_offset kHz, DEFAULT 21400 normally 21400/2m, 44900/UHF tx_power 5W DEFAULT 1W 200mW 50mW transmitter power ptt_origin DTR2 DEFAULT MISO none MISO needs +5VDD pullup pll_delay 0...65535, DEFAULT 100 msecs to wait for PLL lock pwr_delay 0...65535, DEFAULT 100 msecs to wait for power to rise data_delay 0...65535, DEFAULT 100 msecs to wait before sending afsk use_busy on off DEFAULT use BUSY input for dcd and squelch. not RSSI use_softdcd on off DEFAULT use software hack for dcd. not BUSY or RSSI squelch 0...65535, DEFAULT 100 squelch open/close level. see rssi with 'stat' squelch_delay Voice, Scanner 0...65535, DEFAULT 100 msec of opening delay squelch_tail Voice, Scanner 0...65535, DEFAULT 100 msec of hang delay squelch_bilevel Voice, Scanner 0...65535, DEFAULT 200 no hang delay if rssi was over this rssi_1led Voice, Scanner 0...65535, DEFAULT 100 signal strength to leds rssi_2led Voice, Scanner 0...65535, DEFAULT 200 signal strength to leds rssi_3led Voice, Scanner 0...65535, DEFAULT 300 signal strength to leds mycall 11 characters callsign and ssid, like OHnABC-n myalias 11 characters alias for digipeater, like RELAY. ssid usable mydomain 11 characters kind of admin alias, for remote cfg. ssid usable rfpasswd 15 characters password for remote cfg. unique mycall suggested mytype Tracker normal DEFAULT object item what kind of animal I am. see myname myname Tracker 9 characters object/item name. A-Z 0-9 only suggested mysymbol Tracker 2 characters 2 characters or name. try help symbols bullgroups Tracker 31 characters bulletin groups, blank separated persistence 0...255, DEFAULT 64 0 polite, 255 pig slottime 0...65535, DEFAULT 100 msec. channel access timing txlimit 0...65535, DEFAULT 300 bytes (approx). limit a single keydown kiss_trick KISS 0...65535, DEFAULT 0 'token ring'. 0 disable. 1-15 sets also portnum track_distance Tracker 0...65535, DEFAULT 1852 meters travelled between reports. 0=disable track_interval Tracker 0...65535, DEFAULT 1801 seconds between reports. 0=disable track_limiter Tracker 0...65535, DEFAULT 30 seconds between reports, at minimum track_turnslope Tracker 0...65535, DEFAULT 3600 km°/h factor of CornerPegging. 0=disable track_highg Tracker 0...65535, DEFAULT 40 sideways acceleration in turn. 0=disable track_lowg Tracker 0...65535, DEFAULT 10 sideways acceleration after turn digipath Tracker 79 characters normal tracker digipath. blank separated longpath Tracker 79 characters far reaching tracker digipath. blank separated long_area Tracker 0...65535, DEFAULT 10000 meters between longpath reports. 0=disable long_time Tracker 0...65535, DEFAULT 3600 seconds between longpath reports. 0=disable long_comment Tracker 35 characters appended to longpath reports short_comment Tracker 8 characters appended to normal reports aprs_dst Tracker 11 characters destination of aprs reports, default APRS-0 altnet Tracker 9 characters required destination in incoming packets. * and ? wildcards. default=* target_type Tracker none DEFAULT object item is the target object or item ? none=disable target report target_name Tracker 9 characters object/item name of GPS GoTo. * means put unique digit. default=wpt_name target_symbol Tracker 2 characters 2 characters or name. try help symbols target_comment Tracker on off DEFAULT show active Goto in report use_compression Tracker on off DEFAULT base91 compression when possible radio_range Tracker 0...65535, DEFAULT 10 kilometers. in stationary compressed reports send_altitude Tracker on off DEFAULT report altitude if possible gps Tracker generic DEFAULT Garmin Magellan Aisin SiRF TripMate EarthMate Zodiac SeaTalk Oncore type of gps used gps_lat Tracker 10 characters default latitude. like 6103.52,N gps_lon Tracker 10 characters default longitude. like 2806.21,E nmea_regen Tracker on off DEFAULT relay some sentences back to asy waypoints Tracker on off DEFAULT reports to gps wpts waypoint_tidy Tracker 19 characters blank separated prefixes peeled from wpt names. -l lcase -a as-is -F hex_ssid waypoint_area Tracker 0...65535, DEFAULT 0 kilometers. reports far away are ignored use_mic_e Tracker on off DEFAULT send MIC-E formatted report mic_e_ssid Tracker none DEFAULT wide-1 wide-2 wide-3 wide-4 wide-5 wide-6 wide-7 north south east west north+wide south+wide east+wide west+wide MIC-E path mic_e_msg Tracker off-duty DEFAULT en-route in-service returning committed special priority emergency 0 1 2 3 4 5 6 MIC-E status tracker_digi Tracker none DEFAULT relay wide hesitant RELAY or normal digi. myalias RELAY suggested relay_viscosity Tracker 0...65535, DEFAULT 10 seconds. wait other RELAY to act first dupe_age Tracker 0...65535, DEFAULT 30 seconds. ignore duplicates digi_area Tracker 0...65535, DEFAULT 10 kilometers. far away reports are ignored telemetry_format Tracker 19 characters telemetry mapping. 5+8+N chars. no default faith_in_pll Tracker on off DEFAULT ignore UNLOCK. AN5 generic A/D battscale Tracker 0...65535, DEFAULT 150 scale A/D to deciV. see 'batt' anemoscale Tracker 0...65535, DEFAULT 2237 scale pulse/msec to mph vaneoffset Tracker 0...65535, DEFAULT 0 wind vane offset lcd Tracker none DEFAULT 1x16 2x16 4x16 1x20 2x20 4x20 2x24 2x40 1x8 (null) manipulator Tracker none DEFAULT * DTR2 (null) rn3_function Tracker none DEFAULT weather keypad what is wired at RN3 wx_dump Tracker on off DEFAULT weather data to asy