----------- VERSIO 1.1 ----------- Fri Mar 17 17:50:29 EET 2000 - tmx1v11.bin Luuri hsn2 ei ole muuttunut vaan hsn2v14.bin käypi pariksi. Pientä närkkimistä siellä sun täällä. Skanneria ei ole edelleenkään. Bugeja on varmasti. Muutamat asetukset on "järkeistetty" prosenteiksi, ihan kiusallaan, että hyvä kahlata läpi pikaisesti. Tai, resetoida. Itse asiassa toivoisin viitseliäitä tutkimaan CTCSS:n generointia audiokortin i8253:n OUT2-karvasta. Timerin vieressä on tupladiodi, Synteesiä kohti olevassa jalassa on (?) CTCSS-kanttia 0/+5V, kun laittaa HOTLIST>CTCSS:ään SEQ1 ja TXTONE>Serie1 esmes 130. Eli käytetään ekaa äänimuistia CTCSS:llä, taajuus 130 Hz. Toinen juttu on STATUS>Center. Onko sen lukema 0 oikein, kun tulee oikeaa taajuutta sisään ? Lukemaa ei ole skaalattu, asteikko on .....31850, 0, 1, 2, ... jossa 0 olisi keskellä, ja -1, -2 niitä isoja lukuja. Kohdallaan olevilla rigeillä siinä harhailisi siis 31850, 0 ja 1. Juha, OH5NXO, Juha.Nurmela@quicknet.inet.fi ----------- VERSION 1.2 ----------- About half of the settings have no official position yet. Puolella asetuksista ei ole mitään virkaa. !!---------------------------------------------------------------------- !! SETUP !!---------------------------------------------------------------------- !! RESERVED !! No functionality. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! HOTLIST !! Often used things (?) !! DTMF, CCIR, CTCSS and RGR BEEP index into series in TX TONES. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! BAND CFG !! CallFreq and MostUsed are quickly selectable with successive OKs. !! Rptr Low/High limit an area which automatically selects duplex !! (duplex is cleared outside this area). !! Implied gives the missing digits for shorter frequency entry. !! Ch Step affects NEXT/PREV buttons and scanner. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! DUPLEX !! In effect outside of memories. Also these are saved in memories !! at the moment the memory is stored. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! PARENTAL !! Few levels of guard against misuse. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! MISC CFG !! Mic parameters XXX !! On- and Off-hook index into SCRIPTS. They allow automatic execution !! of anything when the handset is replaced to or removed from the cradle. !! CW parameters XXX !! MyCall XXX !! MBUS Id XXX !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! VOLUMES !! LFU Vol. presets the audio level from the radio part. Normal !! volume adjustment with +/- is done in the handset. !! Keyclick XXX !! Alert XXX !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! TX TONES !! Stores a number of preset ready-to-use tones, used thru HOTLIST. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! STATUS !! A/D and AFC readouts. read-only. Also some debugging help. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! DEFAULTS !! DISASTER clears all ram in radio. Used when taking radio into ham use. !! RST Some sets defaults for most parameters. After sw upgrade. !! RST Mems wipes out memories. Parameters are unaffected. !! AFC Ctrl VCTCXO adjusment. 50% recommended. !! Deviatio Deviation control. Experiment. !! 1st I/F Keep the default. !! Inj.Side Likewise. !! Dolby Select compander method. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! SQUELCH !! SQ Level Average of opening- and closing levels. !! SQ Hyst. The separation between above levels. !! SQ Delay Slowness of squelch to open !! SQ Tail Slowness of squelch to close !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! SCANNER !! Sc Delay Time before restarting scanning from loss of signal !! Patience Scanning is restarted from frequencies having a continuous signal !! StepRate Time for receiver to wake from frequency change !! Sc Low/High limit an area to scan, with modes 1 and 2. !! Sc3 Fq Few spot-frequencies to scan with mode 3 !! AutoScan Scanning starts automatically with the last mode after !! no activity either from receiver or from operator. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! WARNINGS !! A limit for stuck transmission. !! Low voltage and overtemperature limits. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! REJECTS !! Few frequencies weeded out from scan ranges 1 and 2. These !! are permanent. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! SCRIPTS !! Commands executed after certain events happen. !!---------------------------------------------------------------------- !!---------------------------------------------------------------------- !! PUTES !!---------------------------------------------------------------------- Sat Mar 18 15:29:31 EET 2000 Viitsöreitä, Auto-Duplex area, legal TX area, kivempi Center-näyttö. Juha, OH5NXO ----------- VERSIO 1.5 ----------- Wed Mar 29 00:39:54 EEST 2000 TMN-1 ja/tai TMF-1 hakemistoihin: tmx1v15.bin tmx1v15.asm.gz Ei pal mittään uutta, pari Veskun huomaamaa pikkubugia brownin liikkeenä korjattuna, mutta sit hassumpi homma, se setupin Dolby DBX pistää nmt- kompanderin päälle. Saattaa parantaa äänenlaatua jos molemmissa päissä on "tolpy", koittakaas ken viitsii... Juha, OH5NXO ----------- VERSION 1.7 ----------- Monday 14th April 2000 Started working with the battery charger. Menu is ready, but no charger functionality yet. The current (from 1.4 on) charger is dangerous. It will overcharge the batteries until the internal overtemperature fuse cuts the current flow. When the temperature has dropped enough, the charger will again recharge the battery that is already full... So let's be careful out there... Hopefully I have soon time to implement the charger temperature and voltage limits and maybe later on the delta-V also. Vesa, OH3NWQ http://www.funet.fi/~oh3nwq/oh3nwq.html ----------- VERSION 1.9 ----------- Wednesday 26th April 2000 This is a interim version, where you can modify the charger current. This is done by BCON setting in the HOTLIST menu. This will be changed to work automagically - soon. Vesa, OH3NWQ http://www.funet.fi/~oh3nwq/oh3nwq.html ----------- VERSION 2.0 ----------- 29.4.00 late at night Charger should work now... (2.1 skipped) ----------- VERSION 2.2 ----------- 01.05.00 OH3NWQ Charger switch now functioning Temperature limits now in degrees. Current monitor still shows funny numbers I<128 battery is discharging I>128 battery is recharging ----------- VERSION 2.3 ----------- 03.05.00 OH3NWQ Charger switches on and off more quickly, when configured for trickle charging. ----------- VERSION 2.4 ----------- 04.05.00 OH3NWQ Charger now trickles if Vmax is reached. Trickle current can be adjusted. If you set it to 0%, it will not trickle. If the Tmax is reached, current is adjusted to 0% automatically. ----------- VERSION 2.6 ----------- 08.06.00 OH3NWQ Automatic sanity checking and restoring of defaults. PIN code implemented. Transverter offset - partially implemented 99 MUTE function - working sometimes (buggy) ----------- VERSION 2.7 ----------- 08.06.00 OH3NWQ PIN code echoed as *'s Lights not turned off before the bye bye message ----------- VERSION 2.8 ----------- 12.06.00 OH3NWQ checking of the last number in PIN code ----------- VERSION 2.9 ----------- 20.06.00 19:16 OH3NWQ - two software versions that can be used on TMx1 radios, only the reset default values are different - the light control (in MISC CFG menu) - corrected one bug and created intentionally another - working on the 99-mute - is it better now? ----------- VERSION 3.0 ----------- 25.06.00 12:00 OH3NWQ - corrected the default scanner band limits for TMN1 (f.sc2 > f.sc1) - finished the 99_mute - favourite qrg after reset_some - if sw change tmn1 <-> tmf1 do reset_some - timeout for menu implemented - does not do anything though ----------- VERSION 3.1 ----------- 26.06.00 17:44 OH3NWQ - sanity of the memories now checked on boot (not just parameters) - rejects respected in scanning - center display sign corrected - center offset in displayed in Hz (not 14.3 Hz ticks)